Worx WG261E.1 Manual De Instrucciones página 9

COMPONENT LIST
1. BATTERY PACK RELEASE BUTTON*
2. BATTERY PACK*
3. REAR HANDLE
4. FRONT HANDLE
5. SAFETY GUARD
6. FRONT SWITCH LEVER (ALL AROUND
SWITCH FUNCTION)
7. REAR SWITCH LEVER
8. BLADE
9. BLADE SHEATH
*Not all the accessories illustrated or
described are included in standard delivery.
TECHNICAL DATA
Type Designation: WG261E WG261E.1
WG261E.9 (230-269- designation of
machinery, representative of cordless hedge
trimmer)
WG261E/
WG261E.1
Voltage
Power
No load speed
Max. cutting length
Cutting diameter
Charging
time(WG261E)
Charging
time(WG261E.1)
Machine Weight
**Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.
Cordless Hedge Trimmer
WG261E.9
220-240V~50/60Hz
20V Max** Lithium
2200/min
44cm
16mm
58 mins
230 mins
2.4 kg 2.0 kg
NOISE INFORMATION
A weighted sound pressure
A weighted sound power
Wear ear protection
VIBRATION INFORMATION
Vibration total values (triax vector sum)
determined according to EN 60745:
Vibration emission value: a
Uncertainty K = 1.5m/s²
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
L : 69.6dB(A)
pA
K = 3 dB(A)
pA
L : 82.45dB(A)
wA
K = 3 dB(A)
wA
= 2.2m/s
2
h
EN
9