Bodum 10661 Instrucciones De Uso página 4

OPERATION
– Before using your Milk Frother insert the
batteries into the frother lid as described
in «Inserting/exchanging the batteries»
below.
– Place the frother on a flat, non-slip
surface.
– Pour the milk into the beaker (no further
than the MAX mark).
– Place the lid on the beaker.
– For best frothing results press the on/off
button on top of the lid for approximately
10 seconds, then pause for a short while.
Repeat this process (pressing for 10 seconds
then pausing) until the froth has formed.
– Keep an eye on the consistency of the
froth in the beaker and adjust the
frothing time according to preference.
– Stop the frother and remove the lid.
– After frothing, let the froth stand for a
short while (approx. 30 seconds).
– Using a spoon, start by holding back the
froth while pouring the milk into the
coffee.
TIP: cold, reduced-fat milk can yield more
froth.
TIP: if you prefer warm froth, either a)
remove the frother lid and heat up the cold
froth in the microwave for approx. one
minute, or b) pre-warm the milk before
frothing (to no more than 70°C).
3