Descargar Imprimir esta página

PNI ESCORT HP 6550 Manual De Usuario página 9

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 24
PNI ECH01 ECHO AND ROGER BEEP MODULE
The echo and roger beep module PNI ECH01 is designed to work together with any CB and VHF/
UHF transceiver as an additional module, having as main functions:
Generating the echo effect of the signal captured by the transceiver's microphone and
inserting it in the modulation level;
Generating a custom signal (MP3 audio file) at the end of the transmission and maintaining it.
TECHNICAL SPECIFICATIONS
Supply voltage: 5V
Idle current: 6 mA
Operating current: 56 mA
Distortion ~ 3.72% (depending on microphone capsule)
Supported files: MP3, WAV
Audio file length: 1.5 sec. (firmware V1.0)
COPY MP3 FILE TO ECHO AND ROGER BEEP MODULE
Copy an MP3 / WAV file to the Echo and Roger Beep module following the steps below:
Note: The module is connected at the factory to the PNI Escort HP 6550 CB radio
Turn on the CB radio.
Switch the button on the module to the Open position.
Connect a USB - Micro USB data cable between the PC (laptop) and the echo module.
Delete the existing file and copy the new file.
To disconnect, safely remove the module ("Eject" or "Safely remove mass storage").
Disconnect the USB cable - Micro USB.
Switch back the button on the module to the Close position.
Caution: Do not transmit with the CB radio while the module is connected to the computer
via a micro USB cable.
THE AUDIO FILE MUST HAVE THE FOLLOWING TECHNICAL CHARACTERISTICS
Length max. 1.5 seconds
Transmission speed 8- 320Kbps
MP3 / WAV file type
Medium volume level.
9
EN

Publicidad

loading