Topcom TWINTALKER 1302/RC-6400 Manual De Usuario página 8

TOPCOM TWINTALKER 1302/RC-6400 DUO COMBI PACK
14.6 MONITOR
You can use the MONITOR feature to check for weaker signals in the current channel.
• Press button for normal monitoring .
• Press and hold . After 5 seconds you can release the button. You are now continuous monitoring the channel
until you press again.
14.7 CHANNEL SCAN
CHANNEL SCAN performs searches for active signals in an endless loop from channel 1 to 8.
• Press and hold
• Release the buttons.The channel on the display changes as it scans through the channels.
SC
• When an active signal (one of 8 channels) is detected, CHANNEL SCAN pauses and you will hear the
active signal.
TX RX
• When an active signal (one of 8 channels) is detected, press
and continue to search for another active channel
• Press
PTT
scan.
14.8 BUTTON LOCK
• Press and hold
SC LOCK icon is displayed on the LCD Screen.
• Press and hold
TX RX
14.9 CALL TONES
A call tone alerts others that you want to talk.
a. Setting the Call Tone
5 different Call Tones can be selected.
• Press
SC
• Press
• Press
TX RX
PTT
b. Sending a call Tone
Press briefly. The call tone will be transmitted for 3 seconds on the set channel.
14.10 KEY-TONE ON/OFF
When a button is pressed, the unit will beep briefly.
To set the key-tone.
• Press
SC
• Press
• Press
TX RX
PTT
8
and for 2 seconds.
to communicate through the active signal channel or press
for 2 seconds to activate or deactivate the BUTTON LOCK mode. The BUTTON
again to deactivate BUTTON LOCK
2 times. CA will be displayed.
or to select another call tone or select OF to enable call tones.
to confirm your selection and return to the standby mode.
3 times. 'to' will be displayed.
to enable (ON) or disable the key-tone (OF).
to confirm your selection and return to the standby mode.
or to bypass the current channel
TOPCOM TWINTALKER 1302/RC-6400 DUO COMBI PACK
to deactivate channel