Bosch PLR 40 C Manual Original página 26

OBJ_BUCH-2312-002.book Page 26 Tuesday, November 11, 2014 12:50 PM
26 | English
Henk Becker
Executive Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
70764 Leinfelden-Echterdingen, GERMANY
Leinfelden, 06.11.2014
Assembly
Inserting/Replacing the Batteries
Using alkali-manganese or rechargeable batteries is recommended for operation of
the measuring tool.
Less measurements are possible when using 1.2 V rechargeable batteries than with
1.5 V batteries.
To open the battery lid 9, press the latch 10 in the direction of the arrow and remove
the battery lid. Insert the batteries/rechargeable batteries. When inserting, pay atten-
tion to the correct polarity according to the representation on the inside of the battery
compartment.
If the battery symbol first appears in the display, then at least 100 measurements
are still possible. When the battery symbol is empty, you have to replace the batter-
ies/rechargeable batteries because measurements are no longer possible.
Always replace all batteries/rechargeable batteries at the same time. Do not use dif-
ferent brands or types of batteries/rechargeable batteries together.
 Remove the batteries/rechargeable batteries from the measuring tool when
not using it for longer periods. When storing for longer periods, the batteries/re-
chargeable batteries can corrode and self-discharge.
Operation
Initial Operation
 Do not leave the switched-on measuring tool unattended and switch the mea-
suring tool off after use. Other persons could be blinded by the laser beam.
 Protect the measuring tool against moisture and direct sun light.
2 609 141 213 | (11.11.14)
Helmut Heinzelmann
Head of Product Certification
PT/ETM9
Bosch Power Tools