Husqvarna CS 2512 Manual De Instrucciones página 11

Placement of the cooling water
NOTICE! In order for the water to cool the wire as intended
during cutting, it is essential to adjust the position of the
cooling water as the material is cut. Remember to always
stop the machine when you do this.
Husqvarna CS 2512 is equipped with two outlets for the
cooling water. Ideally, Husqvarna water spears can be
connected to these. The water spears are then placed where
the wire enters the concrete. In this way the wire takes water
with it into the cut, which results in the concrete dust binding
and that the wire is cooled efficiently.
In addition to the cooling water from the water spear, the wire
is rinsed by the two swivel wheels on the machine. This is to
keep the wire as clean as possible, which means that the saw
can work with less friction losses and greater efficiency as the
wire becomes cleaner.
All manuals and user guides at all-guides.com
ASSEMBLY
Connect the hydraulic unit
When the saw is assembled appropriately, it should be
connected to a hydraulic unit. Husqvarna CS 2512 is
designed for use with Husqvarna PP 455 or Husqvarna RC
455.
1 Check that the hydraulic unit is connected to the power.
2 Connect the cooling water to the motor on the hydraulic
3 Check that the display on the remote control shows
4 Fit the pressure reduction block on the hydraulic unit as
5 Connect the two smaller hydraulic hoses to the pressure
6 Lock the couplings by turning the sleeve on the coupling
7 Fit the two hoses connected on the pressure reduction
8 Connect the water hose to the incoming water on the saw.
9 Fit the two large hydraulic hoses on the unit first and then
NOTE!
If the couplings jam when assembling, they should be
removed completely before being refitted.
Make sure that the couplings on the hoses not in use do not
lie directly on the ground.
Always keep the couplings as clean as possible. A clean
coupling lasts longer.
unit.
'CONNECT HOSE BUNDLE". If not follow the instructions
in the Operator's manuals for PP 455E or RC 455.
set out in the instructions on the block.
reduction block. The hoses in the hose bundle marked
with a red disc by the coupling shall be connected to the
hose on the pressure reduction block that is also fitted
with a disc.
so that the slot moves away from the ball.
block to the hoses to the feed cylinder on the saw. The
hoses in the hose bundle marked with a red disc by the
coupling shall be connected to the hose on the saw that is
also fitted with a disc.
to the saw motor connections. Lock the couplings by
turning the sleeve on the coupling so that the slot moves
away from the ball.
– 11
English