Hitachi ULTRAVISION Director's Serie Guia De Funcionamiento página 57

Channel Manager
Channel Manager
Select CHANNEL MANAGER to set your Antenna
options, run Auto Channel Scan, Check Signal Meter
and Set Channel List.
1. Press CURSOR PAD
2. Press the SELECT button or CURSOR PAD
select.
Signal Meter
Select SIGNAL METER when using an indoor or outdoor
antenna. This feature will show the signal strength and
peak values of the Antenna signal to help you adjust your
antenna to optimize signal reception.
Also this feature will show you the status of the Out
Of Band (OOB) channel, if locked or unlocked as
monitoring the noise rejection and the frequency values
of the OOB channel.
Use the CURSOR PADS and the SELECT button to
highlight and select CLOSE to exit.
NOTE: 1. The Signal Meter will not be available (grayed
out) when watching analog channels.
2. The OOB options work only for CableCARD
channels.
Auto Channel Scan
This feature will automatically store active Analog and
Digital channels in Auto Channel Scan memory.
1. Use the CURSOR buttons
CABLE (1) or CABLE(2) source.
2. Press the CURSOR buttons
START or RESET option.
3. Press the SELECT button to select.
NOTE: 1. If certain channels are poor or not possible
in cable(1) mode, set cable source to cable(2)
by using the CURSOR buttons
, to highlight functions.
to
or to highlight AIR,
or to highlight the
or .
Video
Audio
TV Guide On Screen
Channel Manager
Locks
Timers
Setup
Power Swivel
Move Select
SEL
Channel Manager
Signal Meter
Auto Channel Scan
OR
Channel List
Move Select
SEL
Channel Manager
Signal Meter
Auto Channel Scan
OR
Channel List
Move Select
SEL
Channel Manager
Signal Meter
Channel 3 - 1
Strength 91
Peak 91
SNR 10
OOB Lock/Unlock Lock
OOB SNR 60 dB
OOB Frequency 105 MHz
Close
Move Return
SEL
Channel Manager
Signal Meter
Auto Channel Scan
Channel List
Move Select
SEL
Channel Manager
Auto Channel Scan
OR
Source Air
Auto Channel Scan
Start
Move Return
SEL
Reset
57