Descargar Imprimir esta página

Hitachi ULTRAVISION Director's Serie Guia De Funcionamiento página 79

Publicidad

Idiomas disponibles

Idiomas disponibles

Setup
CableCARD Information
After the CableCARD has been successfully installed,
you can access CableCARD Information menu in the
SETUP menu of the On-Screen Display.
Follow the instructions below to access the CableCARD
Information menu.
1. Press the MENU button on the Remote Control to
access the Main Menu screen.
2. Use the CURSOR PAD
the Main Menu and press the SELECT button.
3. Use the CURSOR PAD
Information and press the SELECT button.
4. To view the CableCARD ID and Host ID, use the
CURSOR PAD
to highlight CableCARD Info and
press the SELECT button.
NOTE:
The Diagnostics Info. window is for
Service use only.
THINGS TO CHECK WHEN USING THE
CableCARD / CableCARD Services
1. Check that the CableCARD is properly inserted in
the CableCARD slot.
2. Remove the CableCARD by pulling
the CableCARD straight out.
3. Visually inspect the CableCARD to ensure all pin-
holes are in good condition, with none blocked or
damaged.
4. Make sure the CableCARD is re-inserted in the
correct direction, then slowly push until it is fully
seated in the slot.
5. When the CableCARD is installed, note all screen
messages that appear ("CableCARD Installed",
"Acquiring Data", "CableCARD is not Installed").
If the "CableCARD Installed" message does not
appear when card is installed, check the TV's card
slot and CableCARD pins for obstructions or
damage.
6. If problems still remain, please contact your Cable
Service Provider.
NOTES:
1. When a CableCARD is installed, Auto
Channel scan will not be needed
because the channel list is automatically
loaded to the TV's channel memory.
2. The TV will take several minutes to
detect and recognize the presence of the
CableCARD. This process must be
completed before any CableCARD
information or Channel listings is
accessed.
to highlight SETUP in
to highlight CableCARD
Video
Audio
TV Guide On Screen
Channel Manager
Locks
Timers
Setup
Power Swivel
Move
Select
SEL
Setup
Setup The Menu Options
Set The Screen Saver
OR
Set The Inputs
Set The AV Net
Set The Closed Captions
Set The IR Out
CableCARD Information
Select The Quick Start Option
Reset The Software
Move
Select
SEL
Setup
CableCARD Information
Select the button below to acess
CableCARD ID and Host ID.
CableCARD Info.
Select the button below to access
OR
CableCARD and Host Diagnostics.
Diagnostics Info.
Move
Return
SEL
In order to start cable service
for this device, please contact
your cable provider
CableCARD(tm): 123-456-789-1
Host: 123-456-789-1
Data: 123-456-789-1
Unit Address: 123-456-789-1
Press EXIT to return
79

Publicidad

loading

Este manual también es adecuado para:

Ultravision director's p60x901Ultravision director's p50x901