Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Before installation
The information in the operating instructions is for reference purposes only. The physical product may
differ.
1)
Before installing any accessories, ensure that the refrigerator is disconnected from the mains.
2)
Risk of electric shocks!
The water pressure of the device is 147-834 kPa (1.5 - 8.5 kgf/cm). If the water pressure is too high,
install a decompressor.
3)
Please do not connect the water pipe to a water heater.
When laying the pipes, do not bend them. Connect the water pipes carefully.
4)
Do not use old or used water pipes. Buy the joint that connects the pipe with the faucet and install
as shown in the figure.
5)
After 6 months of continuous operation, the
If this happens, replace the water filter.
Joint Connecting tube
2.
Connecting the water pipe (Fig. 1)
1)
Slide the end of the connecting tube into the joint. Attach the joint to the faucet.
2)
Remove the tube cap from the white flexible tube.
Slide the end of the white flexible tube into the connecting tube, which is secured with a circlip. If
necessary, attach the flexible hose to the wall to avoid the risk of tripping.
3)
After connecting the pipes, carefully unscrew the faucet to check that the pipe is tight.
Installation der Wasserleitung
Tube connection
Pipe cap
Circlip
symbol flashes on the display.
Fig. 1
44
Publicidad
