Fax +32 2 359 95 50
ERROR MESSAGES
E1. When the pressing plate stays closed for over 10 seconds, the
buzzer alarm rings, the digital screen shows the red flashing letters
"E1" and "Warning". The heating element will be cut off, and at this
time, only the ON/OFF button will work. To resume operation, please
just raise the pressing plate up.
E2. When the pressing plate stays raised for over 15 minutes without
any operation, the buzzer alarm will ring, the digital screen will show
red flashing letters "E2" and "Warning" only, and the heating element
will be cut off. At this time, none of the buttons will operate, and the
steam press will automatically shut off power after 5 seconds. To
resume operation, just power the steam press on again.
So when the digital screen shows red flashing letters "E1" and "E2", the
function is perfectly normal. This should not be considered as a
malfunction of the appliance.
E3. When the screen shows E3, it means the sensor line did not get
plug correctly or got loose, in this case, please contact customer
service to get the procedure to get the sensor line re-connected
Copies of the I/B. Please reproduce them without any
changes
except
under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
11
Assembly page 11/28
special
instruction
from
Team
Print only
USK STP 23783 - 110127