Fax +32 2 359 95 50
NOTE: Do not press the burst of steam button when the pressing plate
is in its lowest (closed) position!
After a few seconds, lift the handle and raise the pressing plate
•
back to the raised position.
USING THE SPRAY BOTTLE
Lightly spray the garment before placing it on the ironing board. This
helps to distribute an even, fine mist over the fabric, preparing it to
be pressed, and removing all wrinkles.
USING THE PRESSING CUSHION
Some garments have been constructed with details, such as darts,
curved seams and shoulder pads, which are not intended to be
pressed flat. A pressing cushion is supplied with your steam press for
use with these areas.
Use the cushion whenever pressing areas where no creases are
•
desired or to shape tailored garments.
Place the area to be pressed onto the ironing board.
•
Place the pressing cushion under the dart, seam etc.
•
Make sure the area to be pressed is raised and lower the pressing
•
plate. The raised area is the only area the plate should contact.
NOTE: Do not attempt to lower the pressing plate to its lowest
position or lock the pressing plate against the ironing board with
the pressing cushion in place. You MAY DAMAGE the steam press
by doing so.
Raise the pressing plate after a few seconds.
•
STORING
Water may be left in the water tank, because it will not drip out if
•
the machine is stored in an upright position. However, it is
recommended that if the machine will be stored for some time,
that all the water in the unit should be drained by pressing the
burst of steam button until all of the water is pumped out.
Press "ON/OFF", the red power light will go out. Disconnect the
•
plug from the outlet. Leave appliance in open position.
Copies of the I/B. Please reproduce them without any
changes
except
under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
9
Assembly page 9/28
special
instruction
from
Team
Print only
USK STP 23783 - 110127