Audio Pro LIVING LV33 Manual Del Propietário página 7

pairing lv33 speakers witH transmitter
PLAy WIRELESS fROM OtHER SOUND SOURCES
the tXd200 transmitter has a combined analog/optical sound input on its end. you can connect
any device with sound output, optical or analog, to the transmitter. computer, mp3-player, ipod/
iphone/ipad dock, cellphone, stereo/receiver, cd-player, radio, etc. tXd200 contains an advanced
Burr-Brown a/d converter for best sound reproduction. the transmitter tXd200 must be powered
by audio pro usB power adaptor if connected by cable (sold separately).
Connect any device with sound output, optical or analog.
Examples:
iPod/iPhone/iPad dock
Apple tV, Airport Express
Cellphone
CD-player
Network player
Stereo/receiver
tV
Sat/Cable receiver
By pairing, you lock your audio pro network from other peoples audio
pro wireless networks. in unpaired mode, the tXd200 and lv33 will work
with all audio pro living wireless products.
pair yOur lv33 speakers witH tXd200 transmitter
1. press pairing button on transmitter for 2 seconds. led starts to flash
green.
2. press and hold ZOne/pair button on lv33 speaker for 3 seconds.
(lift of cloth grille to access buttons.) led starts to flash green.
3. when leds on both transmitter and speaker goes to steady green, the
system is paired.
note:
1. pairing will not work with older living speakers.
2. to unpair system (all speakers in same volume zone will be unpaired):
- disconnect tXd200 from power.
- while pressing the pairing button, reconnect tXd200 to power, and hold pairing button for
6 seconds.
3. On lv33 speaker; turn speaker off with main switch on rear panel. while turning the
speaker on again, hold the House code button pressed.
The transmitter and speakers will now be unpaired.
to 230V
AC outlet
Optical or
analog cable
7