Publicidad
Idiomas disponibles
Idiomas disponibles
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.
TECHNICAL SPECIFICATIONS
Power supply:
Power consumption:
Dimensions (LxWxH):
Weight:
Maximum ambient temperature T a :
Maximum housing temperature T B (steady state):
Min.distance from flammable surfaces:
Min.distance to lighted object:
Fuse:
Accessory:
GE ELC 24V/250W GX-5.3 50h w. 50mm refl.
OMNILUX ELC 24V/250W GX-5.3 50h 50mm refl
OSRAM ELC 64653HLX A1/259 24V/250W GX-5.3
PHILIPS ELC 24V/250W GX-5.3 50h 50mm refl
GE ELC 24V/250W GX-5,3 500h 50mm Refl.
OMNILUX ELC 24V/250W GX-5.3 500h 50mm ref
PHILIPS ELC 24V/250W GX-5.3 500h 50mm ref
PHILIPS ELC 24V/250W GX-5.3 1000h
Please note: Every information is subject to change without prior notice. 05.03.2007 ©
230 V AC, 50 Hz ~
260 W
325 x 340 x 270 mm
9 kg
45°C
75°C
0.5 m
0.5 m
T 2 A, 250 V
No. 88264000
No. 88264005
No. 88264010
No. 88264015
No. 88264100
No. 88264105
No. 88264115
No. 88264215
18/32
51799332_V_1_1.DOC
Publicidad
