Brandt BPI184HUB Manual De Instrucciones página 31

INSTALLATION INSTALLATION
If you are installing the hob above a drawer, or
above a built-in oven, comply with the dimen-
sions provided on the illustrations to ensure a
sufficient air outlet at the front.
Carefully glue the sealing joint to the entire
surround of the glass hob
the cabinet
Important
If your hob is located above your oven, the hob's thermal safety devices can impede the simultaneous
use of the hob and the oven's pyrolysis programme, display code "F7" in the control zones. In such
circumstances we recommend that you increase the hob's ventilation by creating an opening in the side
of the cabinet (8 x 5 cm).
Electric connections
These hobs must be connected
to the power grid via an all-pole
cut-off device that complies with
installation regulations in effect. A
disconnection device must be in-
corporated into the fixed wiring.
Identify the type of cable of your hob according
to the number of wires and colours.
When switching your hob on or after a lengthy
power cut, a code is shown on the control pad
(this display is reserved for your after-sales
service, where applicable. The user of the hob
does not need to take notice of it).
This information disappears after around
30 seconds.
insert the table into
EN
11