Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLING UNIT
Installing Blower Tube
WARNING:
To prevent serious personal injury, stop
the engine and allow the impeller to stop before attaching
or removing tubes.
WARNING:
To prevent serious personal injury or
damage to the unit, the blower tube must be installed
while operating this unit.
1.
Align the bump on the end of the blower tube with the bump
slot on the bottom end of the blower outlet (Fig. 1).
Blower Outlet
Blower Tube
Bump
2.
Insert the bump on the blower tube into the bump slot on the
blower outlet (Fig. 1).
3.
Twist the blower tube clockwise inside the blower outlet until the
bump locks into place (Fig. 2).
Blower Outlet
Blower
Tube
Installing Nozzle/Curved Tube
1.
Align the bump on the end of the blower tube with the bump
slot on the bottom end of the blower outlet (Fig. 3).
2.
Insert the bump on the blower tube into the bump slot on the
nozzle (Fig. 3).
Nozzle
ASSEMBLY INSTRUCTIONS
Bump
Slot
Fig. 1
Fig. 2
Blower
Tube
Bump
Bump
Slot
Fig. 3
3.
Twist the nozzle clockwise over the blower tube until tight (Fig. 4).
Nozzle or
Curved Tube
Removing the Blower Tube
1.
Hold the unit firmly.
2.
Insert a flathead screwdriver into the Tube Lock. Twist the
screwdriver counterclockwise 1/4 turn and hold it there (Fig. 5).
Tube Lock
Blower
Tube
3.
While holding the screwdriver in a counterclockwise position,
grasp the blower tube and twist it counterclockwise (Fig. 5).
4.
Pull the blower tube from the blower outlet.
Removing the Nozzle/Curved Tube
1.
Hold the blower tube firmly.
2.
Grasp the nozzle and twist it counterclockwise until the nozzle
unlocks from the blower tube (Fig. 6).
3.
Remove the nozzle from the blower tube.
Nozzle or
Curved Tube
6
Blower Tube
Fig. 4
Blower
Outlet
Fig. 5
Blower Tube
Fig. 6
Publicidad
