Silvercrest SMA 500 F1 Instrucciones De Uso página 11

Note: If you want to stop the preparation process before it is finished,
press the function button
You will have to reselect the programme when you resume the prepara-
tion process.
Remove the container 4 from the base 0 and fill it with milk. Add at least
♦
enough milk to reach the MIN mark (= 70 ml) inside the container 4.
However, do no fill it with milk beyond the corresponding MAX marking,
otherwise the appliance will overflow:
–
–
Put the lid 1 on.
♦
Place the container 4 on the base 0.
♦
Note: There is a notch on the lid 1 near the sealing ring 2. Make
sure that the notch is not directly next to the spout of the container 4.
Otherwise, milk may leak through the opening. Turn the notch to another
position on the container wall.
♦ Use the function button
Control lamp
Once a programme is selected by pressing the function button
the corresponding control lamp 5/6/7/8 lights up continuously.
The control lamp 5/6/7/8 indicates the end of the programme by
♦
flashing. The appliance switches off automatically.
If you want to stop the preparation process before it is finished, press
the function button
You will have to reselect the programme when you resume the prepara-
tion process.
│ GB │ IE
■ 8
Up to the lower MAX marking
milk.
Up to the upper MAX marking
heat the milk (with only a little froth).
Programme
Heat milk with stiff froth
5
Heat milk with creamy froth
6
Heat milk with little froth
7
Froth cold milk
8
9 or remove the appliance from the base 0.
9 or remove the appliance from the base 0.
(= 150 ml), if you want to froth
(= 300 ml), if you only want to
9 to select the appropriate programme:
Selection
Press 1x
Press 2x
Press 3x
Press 4x
9,
SMA 500 F1