Publicidad
Idiomas disponibles
Idiomas disponibles
Ref.
Description
Nr.
1
Turning handle M12
2
Thin nut M12
3
4
Upper wheel carrier
5
Thin nut M24x2
6
Screw M6X12
7
Locating sleeve
8
Lower parts
9
Bearing 6004
10
11
Upper stop collar
12
13
Bolt M10X110
14
15
3.2.
Assembling the device
Before starting work, the device should be fixed to a worktop or workspace so that there is a stable and sufficient operating
area for the work.
Operating the tool for certain operations will require exerting considerable force on the handle, thus it is essential that the
tool be mounted to a heavy or immovable work bench or other work surface. Be certain there will be adequate clearance for
the entire range of motion of the handle with no potential pinch points for the operator's hands.
3. Spread some oil on the dies and roller before bending material to make the operation smoother.
3.3.
Device use
Insert the square tube into lower rollers, loosen screw (18), adjust the distance among stop collars (21), fix screw (18).
•
•
Rotate lifter rod (12) to make upper roller (24) move down onto the square tube, rotate crank (3) through handle (1), the
square tube moving among bracket (15).
•
Continue to rotating lifter rod (12) and turning crank (3), bending the square tube to predetermined circular arc. If the
square tube bends in a full circle, you should remove upper axle (29) and bolt (13) first, then take upper wheel set out,
finally remove the material.
•
The distance between two lower wheel set is different, the minimum. bending circle will also be different. The smaller
the distance the smaller the bending circle.
•
Do not roll a stock thicker than the roller's capacity.
3.4.
Cleaning and maintenance
a)
Use only non-corrosive cleaners to clean the surface.
b)
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
c)
Do not spray the device with a water jet or submerge it in water.
d)
The device must be regularly inspected to check its technical efficiency and spot any damage.
e)
Use a soft cloth for cleaning.
f)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they may damage the
surface material of the appliance.
g)
Check for damaged parts. Check for alignment of moving parts, binding, breakage, and mounting or any other condition
that may affect a tool's operation.
h)
Any damaged part should be properly repaired or replaced. Do not perform makeshift repairs.
Crank
U Bracket
Lifter
Washer 10
Bracket
Qty
Ref.
Nr.
16
1
17
1
18
1
19
1
1
20
3
21
2
22
1
23
2
24
1
25
1
26
1
27
2
28
4
29
2
Description
Locknut M10
Lock washer 10
Screw M6X20
Washer
Bearing 61902
Outer stop collar
Low roller
Low axle
Upper roller
Screw M8X20
Space bush
Bearing 608
Bolt 8X30M
Upper axle
Qty
4
4
4
4
4
4
2
2
1
1
1
1
1
1
Publicidad
