Powr-Flite Solar Reach Manual De Instrucciones página 13

Thermal Protector
Your Powr-Flite vacuum cleaner is equipped with a thermal protector designed to
protect your vacuum cleaner from overheating due to restricted airflow (i.e. clogged
hose). Should this situation occur, the thermal protector will automatically shut off
the motor to prevent damage.
How to Reset the Thermal Protector
1. Unplug the vacuum cleaner.
2. Allow the vacuum cleaner to cool at least 30 minutes.
3. Check for blockages, change the vacuum bag and clean or replace the filters.
4. Plug in the vacuum cleaner and begin using.
Problem
Suction power is
weak.
The vacuum does
not work.
Sudden loss of
power.
Dirt and debris are
blowing through
exhaust vent.
All other service should be performed by an authorized service center.
For Best Performance
• Keep machine and all accessories clean and in good operating condition.
• Replace the bag when it is 2/3 full.
• Replace the filters once a year or as needed.
• Always use genuine Powr-Flite filters and parts, as use of other products may
result in poor cleaning or filtration performance. Powr-Flite filtration products
are designed for maximum performance.
• Store machine carefully in a dry area.
• For optimum cleaning performance and safety, follow your owner's manual.
Check Point
• Vacuum bag
• Wand or hose
• Filters
• Power cord
• Thermal reset
• Filters
MAINTENANCE
TROUBLESHOOTING
Possible Solution
• If the vacuum bag is 2/3 full, replace it.
• If clogged or blocked, remove the object.
• Clean or replace filters.
Insert the power plug firmly into an
electrical outlet.
Turn off vacuum and unplug from
electrical outlet. Let vacuum cool down
for at least 30 minutes before turning back
on. Check for clogs. Replace vacuum bag.
Make sure filters are clean, dry and
installed correctly.
13