Mansfield Trio-Fix Manual Del Usuario página 11

• If the machine becomes blocked, it must be turned
off immediately.
• Use only accessories with the same shaft diameter as
that of the chuck.
• Adapt the rotation speed to the type of work
Use a high speed for cutting work and
moderate for polishing work.
Package contents:
1. Trio-Fix multigrinder
2. Safety goggles
3. Accessories – see selection (Fig. 9)
4. User guidelines
5. Warranty certificate.
DESCRIPTION
1. On /off switch with variable speed control (Fig. 1)
2. Release switch for rotation of rotating head (Fig. 1)
3. Release switch for shaft lock (Fig. 1)
4. Rotating head (Fig. 1)
5. Chuck (Fig. 1)
Start, stop and speed regulation
• Turn the multigrinder on and off (Fig. 2) using
the on / off switch.
• Regulate the variable speed by pushing the on
/off switch up or down (Fig. 2)
• If the machine vibrates too much, it may help
to increase the rotation speed.
Replacing accessories
• Disconnect the multigrinder from the mains.
• Fix the shaft lock by holding down the round switch
(Fig. 3)
• Push the accessory between the prestressing bars in
the chuck (Fig. 4) until they can go no further.
• Turn the coupling anticlockwise as far as possible
(Fig. 5) until the accessory is secured.
• Deactivate the shaft lock by releasing the round
switch again.
11
UK
D
F
E
I
DK