Rotation of rotating head
• Disconnect the multigrinder from the mains.
• Pull back the trigger switch (Fig 6) and trigger
the rotating head.
• Rotate the head to the right or to the left (Fig 7)
• Continue the rotation 120 degrees until a noticeable
clicking sound can be heard.
• Before use, check the gearing by turning the
coupling. If the coupling makes a clear clicking
sound (Fig. 8), the rotating head has gone into a
correct gear.
Technical data
Power
Speed (RPM)
Chuck diameter
Weight
Sound capacity
Sound pressure
Vibrations m/s2
Maintenance/Lubrication
• Ensure that the machine is disconnected from
the mains when maintenance work is being carried
out on the machine.
• Dry the multigrinder off after use by drying
the handle and housing with a clean, dry cloth.
• Keep surfaces and ventilation holes free from
dust and dirt.
• Do not use corroded or abrasive cleaners, as
these can damage the machine's plastic parts.
• The machine needs no extra lubrication.
Environment
• In order to avoid damage during transportation,
the machine is delivered in a solid package.
• The packaging is as far as possible made of recycled
materials. Therefore, reuse the packaging.
• Defective and / or scrapped electrical or electronic
machines must be sent to a recycling point.
3.2mm / 2.4mm
12
160W
5000 – 35000
825g
88 dB(A)
74 dB(A)
4.556 m/s²