Publicidad
Idiomas disponibles
Idiomas disponibles
NOTICE: During drive gear mounting, the
surface of the gear stating "out" should
face toward outside (Fig. 33c).
6. Mount the wave washer and the
new wheel on the wheel axle. Note
that the round recess must face
outward.
7. Lock the wheel with the bolt by
tightening the bolt clockwise.
8. Mount the dust cover onto the wheel and press it into place.
REPLACING THE TRAILING SHIELD
WARNING:
mower.
WARNING:
working. Never operate the mower with damaged safety devices. Failure to do so can
result in personal injury. The trailing shield is subject to wear and damage, which could
expose moving parts or allow objects to be thrown. For safety protection, frequently
check the trailing shield and replace it immediately with only the identical replacement
part, listed in this manual.
1. Remove the battery.
2. Turn the mower on its side with the upper surface against a wall.
3. Remove the rear wheel on the top side, following the section "REPLACING THE
WHEELS" in this manual.
4. Loosen the wheel cover locking
screw, then remove the wheel
cover from the wheel shaft
(Fig. 34).
5. Repeat steps 1 to 3 above the
remove the other rear wheel and
wheel cover.
56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2140SP/LM2140SP-FC
Always remove the battery pack when servicing or transporting the
Never operate the mower unless the trailing shield is in place and
33c
34
Wheel Cover
Locking Screw
Wheel Axle
43
Publicidad
