Publicidad
Idiomas disponibles
Idiomas disponibles
▪ Press power switch
▪
Press temperature control button
the LED display from Celsius to Fahrenheit
▪
You can set the desired temperature by pressing
The temperature selected will increase/decrease by 1°C with each press of the buttons.
The temperature range of your wine cellar is set between 5 and 20 °C.
▪
Press the button
➢
Door reverse
The door of the appliance is reversible, the door is set to be hinged right at purchase, you
can change it to the left by following below instructions:
1. Close the door, remove the upper hinge cover and upper hole cover pad on top
side using a flat-head screwdriver. Remove the upper hinge by unscrewing 4pcs
of hex head screws, then remove the door from the cabinet carefully by opening
the door slightly and lifting it up and set it aside. Attention: The door is heavy,
handle it carefully with an assistant.
2. After door is removed, lie down the wine cooler on a soft mat. Remove the lower
hinge at the right bottom and door support at the left bottom.
3. Install the lower hinge to the left bottom and door support to the right bottom.
4. Move the hinge hole cap (at the top of the door) from the left side to the right side.
Move the door stopper (at the bottom of the door) from right side to the left side by
using a Philips screwdriver.
5.
Hold the door carefully and place it on top of the lower hinge
6.
Install the upper hinge at the left top of the cabinet, and cover the upper hole with
upper hole cover pad.
for 3 seconds to turn on or turn off the appliance
and
to turn on or turn off the light.
together for 3 seconds to change
or
32
of each zone
Publicidad
