Jimmy BD7 Pro Manual Del Usuario página 7

Function description
Vacuum+Tap+UV Mode
After power on, the anti-mite vacuum cleaner starts with Vacuum +Tap +UV mode by default,
product power is in normal mode, the corresponding indicator light will be on, and the machine
will start vacuuming function, brushroll tapping function, the UV-C light dust mite-removal
function and the negative ion function; Press the mode button to switch to turbo mode.
Vacuum+UV mode
When product is in Vacuum+Tap+UV mode, keep pressing mode button for 3 seconds to change
to Vacuum+UV mode. Corresponding indicator will be one and product will start vacuuming,
UV-C light dust removal and negative ions function. Press mode button in this status, product
will switch to Turbo mode.
Dust level display
When the cleaned surface is in a clean state, the dust level bar is blue. When the cleaned
surface is slightly dirty, the dust level bar is orange. When it is in a dirty state, the dust
concentration bar is red. As the dust level decreases, the dust level bar slowly changes from red
to orange to blue.
Battery power display
The battery power display is in the form of light band, which is divided into five grids, each
representing 20% of the power; When the power is 100% during the discharge process, the five
indicator lights are cold white, and the corresponding indicator lights are off for every 20% of the
power consumption. When the power is 10% left, the indicator lights are red to remind charging;
During the charging process, the red light will light up and flash when the power is ≤ 10%, and
the cell will turn into a cold white light and start flashing when the power is greater than 10%;
When the power reaches 20%, the next grid light will turn on cold white with flashing. When
the power reaches 40%, the next grid light will jump to the next grid light after every 20% of the
power is fully charged. When battery power is full, the five grids are fully filled with cold white
light.
Brushroll blockage indicator
This indicator flashes when the brushroll is blocked.
Cleaning and maintenance
Note:
1. HEPA filter is available for sale at JIMMY distributor.
2. It is recommended to clean the dust cup in time after each use. When there is too much dust to cause
HEPA blockage, it needs to be cleaned in time or replaced if necessary.
Cleaning of dust cup
Turn off the product, remove the dust cup according to the instruction on the dust cup; Align the
dust cup with the garbage can, press the bottom cover release button, open the bottom cover,
and pour out the garbage. Hold the dust cup with one hand and pull out the filter assembly with
5