Put the machine in cool and dry place if the machine is to be idled. Do Not leave it in direct
sunlight or humid environment.
Trouble Shooting
Please check the following trouble points before go to the maintenance department.
Problems
Possible Reasons
Battery pack not properly assembled
Product does
Battery pack has no power
not turn on
On/off switch is not pressed down
Air inlet blocked
Weak suction
HEPA blocked
Cyclone blocked
Machine tilt and micro switch left
UV light does
cleaning surface
not work
UV light defect
Dust cup full
Machine
stop working
Machine air inlet blocked
suddenly
HEPA blocked
Brushroll entangled
Brushroll
stop working
suddenly
Belt loose or broken
No sufficient
Battery not fully charged
working time
after charging
Battery aged
Note: If there are other faults, special tools must be used, please contact after sales service for guidance.
Solution
Reassemble battery pack
Charge the product
Press down on/off switch
Clean air inlet
Clean dust cup and HEPA
Clean cyclone
Machine tilting degree cannot ex-
ceed 30 degree
Contact after service to replace UV
light
Stop using the product and clean
blockage and use the machine af-
ter 2 hours
Take out brushroll, clean it and re-
assemble
Contact after service to replace
belt
Fully charge battery according to
instruction manual
Purchase and replace battery
7