Overmax X-Strike Manual De Usuario página 18

battery. Do not leave the battery connected to the charge unattended.
Recommended charger parameters: 5V 2A. Charging time is around 120 minutes.
If the battery charge is low, the LVC (Low Voltage Cutoff) protection mode will
EN
be activated, preventing forward and reverse movement.
INSTALLATION OF THE BATTERY IN THE CAR
Place the charged battery in the battery compartment (2, Fig. B) in the car.
Secure the battery using hook-and-loop fasteners (A, fig. 2). Connect the
connectors (B, fig. 2).
BATTERY INSTALLATION IN THE CONTROLLER
1.
Unscrew the battery cover screw with a screwdriver. Slide off the battery
cover (fig. 3).
2.
Insert two AA 1.5 V batteries. Pay special attention to the polarity of
the batteries.
3.
Place the cover back on. Tighten the screw with a screwdriver.
INSTRUCTION FOR USE
1.
Remove the protective film from the car before use.
2.
Press the switch on the car (fig. 4).
3.
Slide the controller switch to the ON position (fig. 5). The indicator lights
on the controller and the car will start flashing. Wait about 15 seconds
for the controller to connect to the car. The indicator lights will start to
illuminate continuously. NOTE! Always switch on the car first, otherwise
the controller may have trouble establishing a connection with the car.
4.
To drive forward, move the throttle backwards. To brake and drive
backwards, move the throttle forward (fig. 6).
5.
To change the direction of the car (left-right), use the control knob (fig. 7).
SPEED CONTROLLER
Use the speed controller to increase or decrease the speed of the car (fig. 8).