Aircast Venaflow Elite 30BI-S Manual Del Operador página 21

Replacement Kit Instructions
Replacement kits may be ordered through customer care .
Replacement Kit Instructions
Instructions for Installing/Removing/
Replacing the Power Cord
1) Make sure system is powered off and unplugged .
2) Remove the screw retaining the power cord cover
using a 1/16" hex driver .
3) Remove the power cord cover .
4) Remove the power cord .
5) Install new power cord and reassemble power cord
cover .
Telescoping Bed Hanger Replacement
1) The telescoping bed hanger piece can be removed
and replaced if necessary .
2) To replace the bed hanger, hold down release
button on the back of the system and firmly pull
bed hanger out of the body of the system .
3) Discard the broken or ineffective hanger . To install
the new bed hanger, slide the new hanger back
into the body of the device and set at desired
length .
Instructions for Replacing Fuses
1) Remove the power cord . Refer to the 'Instructions for installing/removing/
replacing the power cord' section .
2) Remove fuse holder from power entry module .
3) Remove fuses from fuse holder .
4) Replace any blown fuses with 250V, 2A, IEC fast acting
5X20mm fuses .
5) Reassemble fuse holder and replace power cord per
previous instructions .
ENGLISH
17