Asist AE6CS25 Manual Del Usuario página 37

work.
• Keep safety devices, vents and engine cover as free
from dust and dirt as possible. Wipe the device with
a clean cloth or blow it with compressed air at low
pressure.
• We recommend cleaning the device directly after
each use.
• Clean the device regularly with a damp cloth and
a little greasy soap. Do not use cleaning agents or
solvents; these could damage the plastic parts of the
device.
Make sure that water does not get into the device.
Water entering an electrical appliance increases the
risk of electric shock.
Storage
• Store the device in a dry place protected from dust
and out of the reach of children.
• Store grinding wheels in a dry place standing upri-
ght. Do not stack grinding wheels (do not stack).
TECHNICAL DATA AE6CS25
power consumption: 250W
voltage: 230V/50Hz
revolutions: 8400/min
Adjustment angle: 35° left and right
Grinding wheels ( (outside): max. 110 mm
suitable for 3/8" chains
Grinding wheel thickness: 3.2 mm
Weight: 1.68 kg
Protection class II.
Sound pressure level measured according to EN
60745:
LpA (sound pressure) 82 dB (A) KpA=3
LWA (acoustic power) 93 dB (A) KwA=3
Take appropriate measures to protect your hearing!
Use hearing protection whenever the sound pressure
level exceeds 80 dB (A).
Weighted effective acceleration value according to
EN 60745: 3,27m/s2 K=1.5
Caution: The vibration level may vary during
power tool operation from the declared value
depending on the way the power tool is used and
depending on the following conditions: Method of
power tool use and type of material being cut or
drilled, conditions of the power tool and method
of its maintenance, appropriateness of the used
accessories and ensuring its sharpness and good
conditions, the strength of handle gripping, use of
anti-vibration equipment, suitability of the power
tool for the purpose for which it has been designed
and compliance with workflows according to
manufacturer's instructions.
If this power tool is used in an inappropriate manner,
a hand/shoulder vibration syndrome may appear.
Caution: For clarification, it is necessary to consider
the level of vibrations in specific conditions of use in
all operating modes, e.g. the time when the power
tool is switched off except for the operation time,
and when it idles, i.e. performs no work. This may
substantially decrease the exposition level during the
whole operating cycle.
Minimize the risk of vibrations, use sharp chisels, drill
and blades.
Keepthe power toolin compliancewith
theseinstructions and provide for its proper
lubrication.
When using the power tool regularly, invest into anti-
vibration equipment.
Do not use the power tool under temperatures lower
than 10°C. Plan your project containing work with the
power tool producing high vibrations carefully and
spread it over more days.
Subject to changes.
ENVIRONMENTAL PROTECTIONWASTE
MANAGEMENT
Power tools, accessories and packaging should
be provided for recycling and not to harm the
environment.
Do not dispose of power tools into household waste!
According to Directive 2012/19/EU of the European
Parliament and of the Council on waste electrical and
electronic equipment (WEEE) and its approximation
in national laws, unfit power tools must be handed
over at the point of purchase of similar equipment, or
in available collection points designated for collection
and disposal of power tools. Such disposed power
tools will be collected, disassembled and delivered for
environment-friendly recycling.
WARRANTY
In the attached material, you will find our warranty
conditions.
Date of Manufacture
The date of manufacture is incorporated into the
serial number stated in the product nameplate.
The serial number has the format of ORD-YY-MM-
SERI, where ORD is the number of purchase order,
YY stands for the year of manufacture, MM is the
month of manufacture and SERI means the serial
product number.
37