Fermax VDS 1-2L VEO Guía Inicio Rápida página 7

SETTINGS
The monitor supplied in the kit comes PRE-PROGRAMMED from the factory.
If the kit has 2 lines, both monitors, they are PRE-PROGRAMMED.
HOW TO PROGRAM THE VEO MONITOR
1. INSTALL
Monitor powered for the fi rst time.
The fi xed red led indicates that the monitor is powered and on (audio volume).
2. PROGRAM (Panel confi gured as MASTER)
1. With the monitor on, press the programming button. A confi rmation tone will be emitted.
2. Press the call-to-residence button. Again, a confi rmation tone is emitted.
Note: The monitor will not work if it has not been programmed.
1
Note: Maximum conversation time: 90 seconds.
3. PANEL SETTINGS
Focus
camera
Version
amplifi er
1 Door open' warning
language selection
Spanish English
Greek Polish
Danish Icelandic
Programming button
Dutch/
French German
Flemish
Czech Slovak
Turkish
Russian Italian Hindi
VDS
Programming tool

< 2 min
JP2: Main / Secondary Panel Selection
MASTER Panel Default:
SLAVE Panel
LED diagnostic
Blinking to indicate short-circuit between + and L upon
making a call from the panel.
Selecting the language 1
of the message "door open."
Audio Settings
of the Monitor, panel and open door.
Microphone Connection.
Panel Connectors:
+, - : power (18Vdc).
L : data bus.
C, NO, NC: Relay contact, 2A@30Vdc (lock-release connection)
+12: 12 Vdc (0,5A) output
BS, -: entrance hall button.
S : activation of the exchanger
V : live
M: mesh
Catalonian Valencian Balearic
Persian/
Arabic
Chinese
Farsi
Hungarian Hebrew Croatian
MANUAL
FULL
MONITOR
2
Portuguese
Basque
Norwegian Finnish
bell DEACTIVATED
VDS MEMOVISION CITYLINE KIT 1-2L VEO
Galician
Swedish
3