Descargar Imprimir esta página

Qlima FWK 1689A Instrucciones De Uso página 75

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 42
BWK 1622: pic. 6
Shelves (FWK 1689 A / FWK 16129 / FWK 16129 A)
Equipped with a telescopic runner assembly (except for the bottom shelf).
To prevent damaging the door gasket, make sure to have the door all the way
opened when pulling the shelves out of the rail compartment. For easy access to
the bottles: pull the shelves approximately 1/3 out of the rail compartment.
To remove the shelves out of the rail, pull each shelf approximately 1/3 out. Use a
long flat screwdriver to press down the right plastic notch as shown in Figure 9 an
at the same time lift the left plastic notch as shown in Figure 10. Then proceed to
pull out the shelf slowly.
Working climate
The appliance is designed for operating
from SN/N climate (see below climate class
chart). It is recommended to maintain the
ambient around 22-25°C which helps the
appliance working with low power con-
sumption.
If the ambient temperature is above or
below the designed climate range, the performance of the unit may be affec-
ted. For example, the appliance operating in extreme cold or hot conditions
may cause interior temperatures to fluctuate, and the temperature set 4-22°C
may not be reached sometimes.
Wine storage
The standard shelves are optimized for 750ml Bordeaux bottle storage. The
maximum loaded bottles may vary subject to the different size or dimension
of the wine bottles you store, as well as the shelves quantity pre-installed in
the Wine Cooler. (pic. 7)
There are two designs for the pull-out shelves:
1.
The shelves are without telescopic rails, but with a plastic stopper on each
sides of the shelf track to prevent bottles from falling.
2.
The shelves are with telescopic rails, which has stoppers by themselves.
To prevent damaging the door gasket, make sure to have the door opened
fully all the way before pulling the shelves out.
Should the wine cooler be left empty for long periods we suggested that the
appliance is unplugged, and after careful cleaning, leave the door ajar to
allow air to circulate inside the cabinet in order to avoid possible condensa-
tion, mold or bad smell forming.
Energy saving tips
The appliance should be located away from heat producing appliances, and
away from direct sunlight.
Ensure that the unit is adequately ventilated. Never cover air vents.
Only open the door when necessary. Avoid leaving the door open for long
periods or opening/closing the door frequently.
Climate Class
Ambient Temp.
SN
10 - 32 °C
N
16 - 32 °C
ST
18 - 38 °C
T
18 - 43 °C
4
75

Publicidad

loading