Qlima FWK 1689A Instrucciones De Uso página 78

Temperature setting
•
•
•
Warning
•
•
Interior lighting On/Off
•
•
•
Note!
•
Temperature display
•
•
4
78
The temperature setting ranges are 5-12 ºC for the upper zone and 12-22 ºC
for the bottom zone.
Chose zone to adjust by pressing once on: "UP" for upper zone "DOWN" for
lower zone The display with digital flashing indicates the zone ready for tem-
perature setting.
Press "UP" or "DOWN" to set the desired temperature. The temperature will
change 1°C for each time the button is pressed. After 5 seconds, the display
will switch back to show actual temperature in the zone.
To avoid breaking the compressor, please do not turn on the appliance again
within 5 minutes after you turn it off.
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5
minutes before restarting the unit. If you attempt to restart before this time
delay, the Wine cooler will not start.
Touch the lighting button to turn on (or turn off) the interior cool LED
lighting.
The lighting will be continuously on if it is not turned off except for FWK
16177 where it will automatically switch off after 20 minutes. BWK 1607 &
BWK 1622 where it will automatically switch off after 10 minutes.
For BWK 1607 & BWK 1622, If you want the LED light to remain on
continuously, this is possible. Please press and hold the "LIGHT" button for
5 seconds, the display will show "LP".After 4 seconds the display will revert
back to normal and the light will remain on until manually switched off. If
you want to revert back and conserve energy (recommended), please press
and hold the "LIGHT" button for 5 second, the display will show "LF", after 4
seconds the display will revert back to normal, and the light will automatically
switch off after 10 minutes.
The first time to use the appliance or to restart the appliance after having
been shut off for a long time, you may find a few degrees variance between
the set temperature and the displayed temperature. It is normal and every-
thing of the appliance will be in the order after a few hours running.
The temperature is displayed in digital, which is the best way to be read out.
The digital is shown, as the set temperature when you are setting the tem-
perature, and it will change to be the real temperature of the inside cabinet
after 5 seconds without being touched.
When the temperature probe is out of order, the display window will show
with "HH" or "LL" instead of a digital figure while continuous buzz sound
will be heard. In case of this happens, this appliance is considerately designed
to keep periodical running of compressor and fans which helps to keep the
coldness of the inside cabinet to protect your stored wines.