PowerWalker Line Interactive VI 400 SC Guia De Inicio Rapido página 6

PowerWalker 1500/2000 SC
EN

5. Installation and Initial Startup
Before installation, please inspect the unit. Be sure that nothing is damaged.
I: Placement & Storage Conditions
Install the UPS in a protected area that is free of excessive dust and has adequate air flow. Please
place the UPS away from other units at least 20 cm to avoid interference. Do NOT operate the
UPS where the temperature exceeds 0-40° C and the humidity is over 0-90 % RH.
II: Connect to Utility and Charge
Plug in the AC input cord to the wall outlet. For the best results, we suggest charging the battery
at least 4 hours before initial use. The unit charges its battery while connecting to the utility.
III: Connect the Loads
Plug in the loads to output receptacles on the rear panel of the UPS. Simply turn on the power
switch of UPS unit, and devices connected to the UPS will be protected by UPS unit.
Do not attach a power strip or surge suppressor to the UPS.