Product Assembly - Num'axes EVENIMAL ELECTRONIC PET FEEDER Manual De Instrucciones

PRODUCT ASSEMBLY

NOTE: All assembly parts MUST be locked into position.
Attaching the hopper to the base
•
Align the bottom of the hopper to the top of the base
•
Insert the hopper, positioning it so that it sits firmly inside the base.
•
Rotate the hooper clockwise, locking it into position.
Attaching the lid to the hopper
•
Line up the two tabs on the underside of the lid to the arrows on the outside of the hopper.
•
Place the lid on top of hopper, push down, and then rotate clockwise to lock into position.
Attaching the bowl to the base
•
Slide the bowl into the slot on the side of the base
•
Press down to lock the bowl hooks to the base.
NOTE: The main power switch, located on the underside of the base, should already be turned ON. Position the feeder so
the LCD Control Panel is facing you. In order to set desired preferences, press ENTER after completing each step of
programming. Pressing ENTER will also eventually return you to the normal display screen.
Set the time
NOTE: The clock will be blinking "12:00 AM".
•
Press ENTER and the HOUR will start blinking.
•
Set the HOUR using UP and DOWN buttons.
•
If you need to change from A.M. (morning) to P.M (afternoon), keep scrolling and it will automatically change.
•
When the hour is correct, press ENTER and the MINUTES will start blinking.
•
Use UP and DOWN buttons to set up the MINUTES, then press ENTER.
Set the meal
•
Press and hold ENTER. Once Meal is blinking, release the ENTER button.
•
Use UP and Down buttons to select meal 1,2 or 3 then press ENTER.
•
SERVE will now be blinking. Use the UP and DOWN buttons to select SERVE or SKIP, then press ENTER.
•
If you selected SERVE, set the HOUR that is now blinking, using UP and DOWN buttons.
•
When the HOUR is correct, press Enter and the MINUTES will start blinking.
•
Use the UP and DOWN buttons to set the MINUTES, then press ENTER.
•
Now the meal time has been set.
Set the meal amount
•
After you are finished setting the meal time, the AMOUNT icon will start blinking.
•
Use the UP and DOWN buttons to increase or decrease the amount of food you want to be dispensed at that
time.
•
By selecting more bars, more food will be dispensed.
•
Each bars corresponds to approximate measurements of food that are dispensed.
1 Bar = ½ cup (about 50 gr / 1.76 oz )
o
2 Bars = ¾ cups (about 70 gr / 2.46 oz )
o
3 Bars = 1 ½ cups (about 90 gr / 3.17 oz)
o
4 Bars = 2 cups (about 110 gr / 3.88 oz)
o
5 Bars = 2 ½ cups (130 gr / 4.58 oz)
o
6 Bars = 3 cups (150 gr / 5.30 oz)
o
...
o
•
Press ENTER when you are done.
Setting additional times and amounts
PROGRAMMING
9