Package contents
- a collar with nylon strap equipped with short contact points and a rechargeable Ni-MH battery
- a charger
- a magnetic key (magnet)
- a pair of long contact points
Description of the product
Nylon strap
Red light indicator:
battery level indicator
First use
The collar IKI PULSE comes partially charged from the factory. It is necessary to fully charge the
battery of your IKI PULSE collar before the first use (a full charge takes approximately 12 hours).
Charge of the product
To charge your product, the collar must be necessarily turned off.
To charge your product, proceed in the following way:
- Remove the protection tab situated at the back of the collar (See. Diagram 2).
- Plug the charger to the receptacle at the back of the collar (See. Diagram 2).
- Then plug the line cord of the charger on an outlet.
- When the battery is charging, the red light indicator stays constantly lit (the charge of the product
is a slow charge and lasts approximately 12 hours).
Diagram. 2
Diagram. 1
Protection tab
- a small plastic screwdriver (See Diagram 3)
- a neon test lamp
- this user's guide
2 contact points
(short or long)
Gb - 12
Orange mark:
Area where the magnet is located to
switch On/Off
or change operating mode