Makita MLT100 Manual De Instrucciones página 11

009040
(3) When the width of rip is narrower than 65 mm,
the push stick cannot be used because the
push stick will strike the blade guard. Use the
auxiliary fence and push block. Attach the
auxiliary fence to the rip fence with two "C"
clamps.
009041
Feed the workpiece by hand until the end is
about 25 mm from the front edge of the table.
Continue to feed using the push block on the
top of the auxiliary fence until the cut is
complete.
009042
Cross cutting
CAUTION:
When making a crosscut, remove the rip fence
•
from the table.
When cutting long or large workpieces, always
•
provide adequate support to the sides of the table.
The support should be at the same height as the
table.
Always keep hands away from path of blade.
•
1. Push block
1
1. Auxiliary fence
1
1 1. Push block
2. Auxiliary fence
2
Miter gauge
1
2
4
3
008788
Use the miter gauge for the 4 types of cutting shown in
the figure.
CAUTION:
Secure the knob on the miter gauge carefully.
•
Avoid creep of workpiece and gauge by firm
•
workholding arrangement, especially when cutting
at an angle.
NEVER hold or grasp the intended "cut-off" portion
•
of the workpiece.
Always adjust the distance between the end of the
•
miter gauge and the saw blade not to exceed 15
mm (19/32").
Use of miter gauge
1
2
009043
Slide the miter gauge into the thick grooves in the table.
Loosen the knob on the gauge and align to desired
angle (0° to 60°). Bring stock flush up against fence and
slide table, secure it with the clamp on the miter gauge
and feed gently forward into the blade.
Auxiliary wood facing (miter gauge)
008790
11
1. Cross cutting
2. Mitering
3. Bevel cutting
4. Compound
mitering
(angles)
1. Miter gauge
2. Knob