Makita MLT100 Manual De Instrucciones página 9

with the nearmost guide rail.
To secure the rip fence, pivot fully the lever on the fence
holder.
To check to be sure that the rip fence is parallel with the
blade, secure the rip fence 2 - 3 mm (5/64"-1/8") from
the blade. Raise the blade up to maximum elevation.
Mark one of the blade teeth with a crayon. Measure the
distance (A) and (B) between the rip fence and blade.
Take both measurements using the tooth marked with
the crayon. These two measurements should be
identical. If the rip fence is not parallel with the blade,
proceed as follows:
009035
1
008780
1. Secure the rip fence by lowering the lever on it.
2. Loosen the two hex bolts on the rip fence with the
hex wrench provided.
3. Adjust the rip fence until it becomes parallel with
the blade.
4. Tighten the two hex bolts on the rip fence.
008781
CAUTION:
Be sure to adjust the rip fence so that it is parallel
•
with the blade, or a dangerous kickback condition
may occur.
1. Scale
1
1. Hex bolts
Bring the rip fence up flush against the side of the blade.
Make sure that the guideline on the fence holder points
to the 0 graduation. If the guideline does not point to the
0 graduation, loosen the screw on the scale plate and
adjust the scale plate.
1
009036
Connecting to vacuum cleaner
Cleaner operations can be performed by connecting the
tool to Makita vacuum cleaner or dust collector.
009037
OPERATION
CAUTION:
Always use "work helpers" such as push sticks and
•
push blocks when there is a danger that your
hands or fingers will come close to the blade.
Always hold the workpiece firmly with the table and
•
the rip fence or miter gauge. Do not bend or twist it
while feeding. If the workpiece is bent or twisted,
dangerous kickbacks may occur.
NEVER withdraw the workpiece while the blade is
•
running. If you must withdraw the workpiece before
completing a cut, first switch the tool off while
holding the workpiece firmly. Wait until the blade
has come to a complete stop before withdrawing
the workpiece. Failure to do so may cause
dangerous kickbacks.
NEVER remove cut-off material while the blade is
•
running.
NEVER place your hands or fingers in the path of
•
the saw blade. Be especially careful with bevel
cuts.
Always secure the rip fence firmly, or dangerous
•
kickbacks may occur.
9
1. Guideline
2
2. Screw