Makita MLT100 Manual De Instrucciones página 4

the workpiece as in ripping or cross cutting.
NEVER use the tool with a faulty blade guard
or secure the blade guard with a rope, string,
etc. Any irregular operation of the blade guard
should be corrected immediately.
7. Immediately reattach the guard and spreader
after completing an operation which requires
removal of the guard.
8. Do not cut metal objects such as nails and
screws. Inspect for and remove all nails,
screws and other foreign material from the
workpiece before operation.
9. Remove wrenches, cut-off pieces, etc. from
the table before the switch is turned on.
10. NEVER wear gloves during operation.
11. Keep hands out of the line of the saw blade.
12. NEVER stand or permit anyone else to stand in
line with the path of the saw blade.
13. Make sure the blade is not contacting the
spreader or workpiece before the switch is
turned on.
14. Before cutting an actual workpiece, let the tool
run for a while. Watch for vibration or
wobbling that could indicate poor installation
or a poorly balanced blade.
15. NEVER make any adjustments while tool is
running. Disconnect tool before making any
adjustments.
16. Use a push stick when required. Push sticks
MUST be used for ripping narrow workpieces
to keep your hands and fingers well away from
the blade.
17. Pay particular attention to instructions for
reducing risk of KICKBACK. KICKBACK is a
sudden reaction to a pinched, bound or
misaligned saw blade. KICKBACK causes the
ejection of the workpiece from the tool back
towards the operator. KICKBACKS CAN LEAD
TO SERIOUS PERSONAL INJURY. Avoid
KICKBACKS by keeping the blade sharp, by
keeping the rip fence parallel to the blade, by
keeping the spreader, antikickback pawls and
blade guard in place and operating properly,
by not releasing the workpiece until you have
pushed it all the way past the blade, and by
not ripping a workpiece that is twisted or
warped or does not have a straight edge to
guide along the fence.
18. Do not perform any operation freehand.
Freehand means using your hands to support
or guide the workpiece, in lieu of a rip fence or
miter gauge.
19. NEVER reach around or over saw blade.
NEVER reach for a workpiece until the saw
blade has completely stopped.
20. Avoid abrupt, fast feeding. Feed as slowly as
possible when cutting hard workpieces. Do
not bend or twist workpiece while feeding. If
you stall or jam the blade in the workpiece,
turn the tool off immediately. Unplug the tool.
Then clear the jam.
21. NEVER remove cut-off pieces near the blade
or touch the blade guard while the blade is
running.
22. Knock out any loose knots from workpiece
BEFORE beginning to cut.
23. Do not abuse cord. Never yank cord to
disconnect it from the receptacle. Keep cord
away from heat, oil, water and sharp edges.
24. Some material contains chemicals which may
be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.
25. The guard can be lifted during workpiece
setup and for ease of cleaning. Always make
sure that guard hood is down and flat against
sawtable before plugging in the tool.
SAVE THESE INSTRUCTIONS.
WARNING:
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
INSTALLATION
Positioning table saw
(13-3/8")
340 mm
008792
4
1. Hole diameter 8
mm (5/16")
588 mm
(23-1/8")
1