Publicidad
EN
English
INSTRUCTION MANUAL
Air Supply Requirements
1. Supply tool with 90 psig (6.2 bar) of clean, dry air.
Higher pressure drastically reduces tool life.
2. Connect tool to air line using pipe, hose, and
fitting sizes shown in the diagram.
3/8" (10mm)
3/8" (10mm)
Lubrication
1. Motor - Use an air line lubricator with SAE #10 oil,
adjusted to two (2) drops per minute. If an air line
lubricator cannot be used, add air motor oil to the
inlet once a day.
2. Gears - Remove screw (Index no. 27). Use grease
gun C098689 with Mobilux EP-2 or equal grease.
Re-install screw (Index no. 27).
Maintenance
1. Disassemble and inspect air motor every three (3)
months if the tool is used every day. Replace
damaged or worn parts.
2. High wear parts are underlined in the parts list.
3. Recommended accessories:
8940162768
Cutting Wheel 60 Grit
8940162769
Cutting Wheel 80 Grit
8940162770
Cutting Wheel 120 Grit
Copyright 2007, Chicago Pneumatic Tool Company
All rights reserved. Any unauthorized use or copying of the contents or part thereof is prohibited. This applies in particular to trademarks,
model denominations, part numbers and drawings. Use only authorized parts. Any damage or malfunction caused by the use of
unauthorized parts is not covered by Warranty or Product Liability.
1/2" (12mm)
CA048362 (1/2")
3/8" (10mm)
90
0
130
3/8" (10mm)
3/8" (10mm)
CA048360 (1/2")
CA048361 (1/2")
EC DECLARATION OF CONFORMITY
We, Chicago Pneumatic Tool Company, 1800 Overview
Drive, Rock Hill, SC 29730 USA, declare under our sole
responsibility that the product to which this declaration
relates, is in conformity with the requirements of the
Council Directive of June 1998 on the approximation of
the laws of the Member States relating to machinery
(98/37/EC).
Machine Name RP9118 2" Angle Grinder
Machine Type Power tool equipped with 3/8"-24
spindle for use with various grinding wheels - No
other use is permitted.
Serial No. Tools with No. C00501-2007 or higher
Technical Data
2" (50.8 mm) Grinding wheel
Air pressure 90 psi (6.2 bar)
Harmonized Standards Applied EN792-9
National Standards Applied ISO 8662-4, ISO 15744-
2002
Name And Position Of Issuer Stéphane
Rakotoarivelo, General Manager, CP TechnoCenter,
Saint Herblain, France
Signature Of Issuer
Place And Date Of Issue 44818, Saint Herblain,
FRANCE, January 20, 2007
Noise & Vibration Declaration*
Sound pressure level 81 dB(A) uncertainty 3 dB(A),
in accordance with ISO 15744-2002. For sound
power, add 10 dB(A).
Vibration value 8.5 m/s , re. ISO 8662-4.
* These declared values were obtained by laboratory
type testing in compliance with the stated standards
and are not adequate for use in risk assessments.
Values measured in individual work places may be
higher than the declared values. The actual exposure
values and risk of harm experienced by an individual
user are unique and depend upon the way the user
works, the workpiece and the workstation design, as
well as upon the exposure time and the physical
condition of the user. We, Chicago Pneumatic,
cannot be held liable for the consequences of using
the declared values, instead of values reflecting the
actual exposure, in an individual risk assessment in a
work place situation over which we have no control.
RP9118
Angle Grinder
2
Publicidad
