Publicidad
Idiomas disponibles
Idiomas disponibles
90
THERMEX THO1BFPY
M 905211020227032023
SETUP AND TIMER FUNCTIONS
1. Turn on the oven
connect your oven to the mains, all indicator lights on the display board will light up and then go into the
initial standby mode. During the initial standby state, the system clock is always on. (As shown in Fig. 1.)
when the oven is turned on, the oven door lock will begin to self-inspect. During the self-inspection, the
door lock will automatically move back and forth. If the error code "E-3" appears in the temperature dis-
play during the self-inspection, you can press and hold the KB or K2 " " button to cancel the error code and
return to standby mode.
2. set the clock / system time
In standby mode, press " " once to enter clock setting mode. At this time, the hour icon of the clock ": " will
not flash, but the hour and minute numbers in the display will flash (including the "h" icon and the "min"
icon, 1 time/second)
Set the time by pressing "+" and " —" (0:00~23:59~0:00).
Note: A long press on "+ / —" will incrementally adjust the clock by 5 min at a time. Short press on "+ / —"
will adjust by 1 min.
After setting the clock/system time, wait 10 seconds to automatically confirm the selected time.
when setting hours and minutes, the values for minutes and hours flash; when the clock setting is com-
pleted, if not " " within 10 seconds to confirm, the system will default to complete the clock setting and
exit the clock setting.
If the power is removed from the oven, the clock is reset.
Publicidad
