Welbach ENTRIX 200D Manual De Instrucciones página 34

8.4. Setting the TIG DC welding parameters
Material selection
Turn the knob to select the welding material, then
� �
press or press the knob to confirm and go to the
next step.
Selection of sheet thickness ("Thickness")
Turn and press the knob again to adjust the sheet
thickness and complete the settings. The system
will recommend the appropriate welding current.
Welding can start.
Welding current control ("Peak current")
If necessary, fine-tune the welding current.
Selecting the type of current ("AC/DC")
Aluminum - AC mode (alternating current)
Stainless steel/mild steel/others - DC mode (direct
current)