Publicidad
Idiomas disponibles
Idiomas disponibles
Foldable jack stands, 2 pcs
INTRODUCTION
To get the most out of your new foldable jack stands, please read through these
instructions before use.
Please also save the instructions in case you need to refer to them at a later date.
TECHNICAL DATA
Maximum load:
Min. height:
Max. height:
SPECIAL SAFETY INSTRUCTIONS
Read and understand all warnings and
instructions before use.
Follow the jack stand's rated capacity.
Do not overload.
Please check every time prior to use
that the jack stands are not damaged or
cracked and that the welding joints are
intact.
If there are signs of defects, the jack
stand must be discarded.
You must never attempt to repair a
damaged jack stand.
Do not modify the jack stand's structure
or operation in any way unless speci-
fied in this manual.
Set the jack stand in place on a level
and permanent base, which can bear
both the weight of the jack stand and
that of the car.
Do not operate the jack stand on in-
clined or uneven surfaces.
Be sure to secure the vehicle against
rolling away.
A car must always be supported by 2,
and only 2, jack stands.
2,000 kg
Lift only on the vehicle's lifting points
270 mm
as specified by the vehicle manufac-
turer.
370 mm
Please make sure that you position the
jack stands in such a way that the car's
370MM
lift points are resting in a centered po-
sition on the load bearing surfaces.
270MM
Where one end/side of the car is sup-
ported by jack stands, you must not
lift the other end/side with a hydraulic
jack.
Jack stands must not be used to sup-
port two or three wheeled vehicles or
trailers.
Never sit in the car and never start the
car whilst one side/end of the car is
supported by the jack stands.
NB! Always ensure that you have
secured the jack stands with the safety
pins.
The jack stands must not be used un-
less the safety pins are in.
14
Publicidad
