Husky HD1500 HSDS Manual Del Usuario página 19

PROBLEM OR CONCERN
Leaking water from bottom
of unit
Low pressure
Not building maximum
pressure
Irregular pressure
No water coming out of
Wand
English
POSSIBLE CAUSE
Manifold Assembly is leaking
water
Pump housing is leaking water
Faucet not fully open or unit is
not receiving a full volume of
water
Screen Filter is clogged
Gun or Hose failure
Kink in the Garden Hose or Hose
is wrapped on a storage wheel
Water leaking from either Hose
or Unit
Garden Hose length is too long Shorten the length of the Garden Hose. We
Clogged Nozzle
Air in Pump
No Wand attached to the front
of the Gun
Clogged Nozzle
Quick Connect is attached in-
correctly
Sceen Filter is clogged
Kink in the Garden Hose or
Hose is wrapped on a storage
wheel
19
SOLUTION
Remove the front cover of the unit. If there is
water leaking anywhere from the Manifold
please contact us at customerservice@hus
kypowerwasher.com or order a replace-
ment directly online at www.huskypowe-
rwasher.com.
Email us at customerservice@huskypow
erwasher.com for assistance.
Open the faucet all the way.
Clean the Screen filter as instructed in the sec-
tion 6.4.
Replace Gun and/or Hose. Contact us at c
ustomerservice@huskypowerwasher.
com or order online at www.huskypowe-
rwasher.com.
Unwrap the Garden Hose and lay it out flat to
ensure that there are no kinks in the Hose.
Stop water from leaking before using the unit
or contact us if you need assistance.
recommend a maximum length of 25 to 50
feet for City water supply and 30 feet for Well
water supply.
Clean the Nozzle as instructed in section 6.2.
Let Pressure washer run with Gun trigger de-
pressed and Wand removed until a steady
stream of water is released.
Attach either the Turbo or Adjustable Wand to
the front of the Gun. (High Pressure is created
with the Wand and not the Gun).
Clean Nozzle as instructed in section 6.2.
To Attach Quick Connect properly, keep the
outer collar of the Quick Connect held back
while sliding the Quick Connect all the way
forward against the Inlet Nipple and then re-
lease the collar to lock it into place. (The collar
is spring loaded so if it is released too soon it
will not lock into place).
Clean the Sceen filter as instructed in section 6.4.
Unwrap the Garden Hose and lay it out flat to
ensure that there are no kinks in the Hose.