Technical Data; What Is Not Covered - Husky HD1500 HSDS Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

9.0

TECHNICAL DATA

Pump pressure
1500 psi - 102.4 bar Max.
*Operation pressure
Electrical
requirement
Electrical cord
High Pressure hose
Flow rate
Minimum
amperage source
Pressure of inlet
water
Inlet water
Nozzle spray
angle high pressure
Soap Consumption Rate
* Water flow and maximum pressure ratings determined
in accordance with PWMA. Standard PW101.
If there are missing or damaged parts,
DO NOT RETURN THIS PRODUCT TO
THE STORE.
Our Customer Service Department is available
to help with any problems and operational
questions.
Please visit us at
www.huskypowerwasher.com
English
Limited Warranty
This product is warranted against defects in material
and workmanship for a period of one year on all com-
ponents excluding the gun, hose, lance, and ground
fault circuit interrupter (GFCI) which are only covered
for 90 days; effective from the date of retail purchase
and is not transferable. This warranty excludes inciden-
120v, 15 amps, 60 hz
tal/consequential damages and failures due to misuse,
35 ft. - 10.7 m
abuse or normal wear and tear. This warranty applies
only to products used in consumer (home) applications.
19 ft. - 5.8 m
This warranty does not apply to commercial or rental
applications. This warranty gives you specific rights,
and you may also have other rights, which vary from
1.6 gpm - 6.15 l/m
state to state.
Please visit www.huskypowerwasher.com for details.
15 amp
Please complete and return the enclosed Customer In-
1.36 bar to 6.82 bar
formation Card so that we can reach you in the unlikely
20 to 100 psi
event a safety recall is needed. Register by Internet at
www.huskypowerwasher.com. Return of this card is not
cold tap water
required to validate this warranty.
0-60°
WHAT IS COVERED: Replacement parts and labor.
10% Max
Please note that we reserve the right to repair or replace
the product as we deem appropriate.
WHAT IS NOT COVERED: This warranty does not
include such parts as nozzles which must be replaced
as part of normal maintenance of the equipment, rather
than as the result of a defect. Transportation charges to
warranty center for defective products. Transportation
charges to consumer for repaired products. Damages
caused by abuse, accident, improper repair, or failure
to perform normal maintenance. Use of improper
chemicals or noncompliance with the operators ma-
nuals instructions. Sales outside of the United States or
Canada. Any other expense including consequential
damages, incidental damages, or incidental expenses,
including damage to property. Some states do not allow
the exclusion or limitation of incidental or consequential
damages, so the above limitation or exclusion may not
apply to you. This warranty does not cover damage
resulting from failure to observe any of the following
conditions:
1) The inlet water pressure must be between 20 and
2) The inlet water temperature must not exceed 90°F
3) The unit should not be stored in areas where tem-
22
100 p.s.i.
(32°C).
peratures may drop below 40°F (4°C).

Publicidad

Tabla de contenido
loading

Tabla de contenido