AllTrade TRADES PRO 830271 Manual De Instrucciones página 22

Problem
Unit will not start (when
trigger is depressed)
AC outlet circuit breaker
trips
TROUBLESHOOTING GUIDE
Probable Cause
5. No AC power at the
outlet.
6. Main voltage supply is
too low.
7. Extension cord is too
long or wire size too
small.
8. Defective ON/OFF
Switch.
9. Defective GFCI Plug.
10. Defective Gun.
1. Circuit (outlet)
overloaded.
2. Extension cord is too
long or wire size too
small.
3. Nozzle partially blocked
causing
excessive pressure.
21
Solution
5. Main circuit breaker
is tripped or outlet is
faulty.
6. Make sure main supply
voltage is adequate (See
specifications).
7. Remove extension cord
or use proper extension
cord (See instructions).
8. Call Customer Service:
1-800-423-3598.
9. Call Customer Service:
1-800-423-3598.
10. Turn off the unit.
Remove the Gun and
Hose assembly from
high pressure outlet
in the front of the unit.
Redirect the outlet to
a safe direction and
switch ON the unit. If
the unit starts and water
comes out of the front,
the Gun may need to be
replaced. Call Customer
Service:
1-800-423-3598.
1. Make sure circuit is rated
at 15 amps or greater and
unit is plugged into a
dedicated circuit.
2. Use proper extension
cord (see instructions).
3. Clean Nozzle (see
instructions).