Descargar Imprimir esta página

BGS technic 8437 Manual De Instrucciones página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.
INTENDED USE
This tool set is used for installing the rear axle rubber bushes without removing the rear axle. The tool set
is suitable for Audi A3, VW Golf IV and VW Bora (2001-2003) with engines 1.4 / 1.6 / 1.8 / 2.0L and
1.9D.
SAFETY INFORMATIONS
Read carefully the instructions before working with this tool set.
Do not use this tool set for other purpose for which it is designed.
Observe the general safety instructions for garages.
Keep your work area tidy and clean. Areas or corridors which are untidy increase the risk of
injury.
Lifting of vehicles only allowed on the special lifting points.
Before starting the work under a vehicle always ensure that it is adequately supported by axle
stands or ramps. Chock wheels and ensure that the hand brake is firmly applied.
Always use approved eye protection, especially when working under vehicles.
Ensure a secure and well-gripped stance during fitting.
Check the condition of the tool regularly and do not use it if it is damaged.
Make sure the tool is properly mounted.
Do not over tighten the spindle or apply excessive force, as this may damage both the tool and
the component.
The tool is not suitable for impact wrenches. The use of an impact wrench can rupture tool
parts and flying tool fragments can cause injury.
This manual serves as a brief guide and does not replace a workshop manual. Always refer to
the vehicle-specific service literature, particularly the technical data such as torque values and
instructions for disassembly/assembly, etc.
Fetten Sie immer die Schraubengewinde, ehe Sie das Werkzeug verwenden.
Keep children and other unauthorized persons away from the work area.
Do not let children play with the tool or its packaging and keep this tool out of the reach of
children.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Rear Axle Bush Mounting Tool Set
for VW Golf and Audi A3
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 8437
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed

Publicidad

loading