Publicidad
Idiomas disponibles
Idiomas disponibles
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. Packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with
the environment. Contact your local solid waste authority for recycling information.
COMPONENTS
1
Spindle nut with bearing
2
Mounting cup
3
Spindle
4
Mounting plate
5
Spindle nut with washer
INSTALLING
Remove rear wheels for easy accessibility of the
bushes.
Loosen and remove the trailing arm screws.
Pull down axle part and hold this position by
inserting a distance piece between the axle and
the vehicle underside.
Caution: Make sure that the axle cannot slip.
Marking the installation position of the old bush
(B) on the trailing arm (A).
Dismantle the old rubber bush (B).
Lubricate the new rear axle bush (B) and align
with the mark on the trailing arm (A) and install
the tool as seen in picture.
Turn the nut slowly with a ratchet or wrench until
the rubber bush is attached in the axle.
Turn the spindle nut clockwise by using an air
ratchet, until the rubber bush (B) is completely
installed to the axle housing (A).
Mounting all dismantled parts in reverse order.
Note the installation instructions of the vehicle
manufacturer. For this you need the required
torque values of all screws.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
