Husqvarna LC 142iS Manual De Usuario página 19

Problem Error LED (number
of flashes)
Error LED flashes. 0
The product stops.
3
8
9
12
Other errors. If other errors occur, turn the safety key to 0, remove the battery and speak to an approved
service agent.
Introduction
WARNING:
during transport and storage turn the safety
key to 0, remove the battery and wait a
minimum of 5 seconds.
To set the product in transport position
1. Remove the grass catcher.
2. Loosen the knobs on the upper handle and fold the
handle down. (Fig. 29)
3. Loosen the lower knobs.
4. Move the knobs to the lower end of the grooves on
the left and the right side of the product. (Fig. 44)
5. Fold the lower part of the handle forward. (Fig. 28)
Transportation
• The Dangerous Goods Legislation requirements
apply to the contained Li-ion batteries.
• For commercial transports special requirements on
package and labels must be obeyed.
• Make sure that you obey the regulations for
dangerous material when you prepare the product
for transport. Local regulations can apply.
• Always remove the battery for transport.
• Put tape on the battery connectors and make
sure that the battery cannot move around during
transport.
• Attach the product during transport.
1692 - 005 - 03.11.2022
Cause
Battery connector failure.
There is overload in the mo-
tor.
The battery is weak.
Battery error or no signal from
battery.
Incorrect start procedure. The
motor brake handle has been
engaged before the motor
starts.
Transportation, storage and disposal
To prevent accidental start
Solution
Examine the battery connector.
Increase the cutting height. Refer to
set the cutting height on page 14 .
Charge the battery. Refer to
the battery on page 14 .
Put the battery in the product correctly
and examine the battery connector. If the
error LED on the battery flashes. Refer
Battery charger on page 18 .
to
Release the motor brake handle and
wait approximately 5 seconds. Push the
motor brake handle down again to start
the product.
Storage
• Before storage, let the product become cool.
• Always remove the battery for storage.
• To prevent accidents, make sure that the battery is
not connected to the product during storage.
• Keep the battery charger in a closed and dry space.
• Keep the battery and the battery charger in a dry
space where there is no moisture or frost.
• Disconnect the battery from the battery charger
during storage.
• Do not keep the battery where static electricity can
occur. Do not keep the battery in a metal box.
• Keep the product where the ambient temperature is
between -10°C and 40°C.
• Keep the battery where the ambient temperature is
between 5 °C and 25 °C and out of sunlight.
• Keep the battery charger where the ambient
temperature is between 5 °C and 45 °C and out of
sunlight.
• Make sure that the battery is charged to 30% - 50%
before you put it in storage for long periods.
• Keep the product, battery and battery charger in
a locked area out of reach for children and not
approved persons.
• Clean the product and make sure that the grass
catcher is empty.
• Do the maintenance procedures given in this
operator's manual. Refer to
16 .
To
To charge
Maintenance on page
19