Publicidad
Idiomas disponibles
Idiomas disponibles
Inserting the needle
Attention: Turn power to "off" position before inserting the needle, to avoid electrical shock.!~!
Change the needle regularly, especialy if it is showing signs of wear and causing problems.
Insert the needle as follows:
Loose the needle clamp screw(no.13) and tighten again after
inserting the new needle.
The flat side of the needle should be towards the back. Insert
the needle as far up as it will go.
(Needle clamp screw no.13)
Attaching the presser foot holder
The machine has the standard pressure foot, used for sewing of different fabrics. For the
sewing of button holes and zippers you have to place another pressure foot on the machine.
See the following description with illustrations how to replace the pressure foot.
Figure 1. Put the pressure foot lever (no.18) up. Place the foot clamp (B) on the pressure foot
lever and tighten screw A fixed.
Figure 2. Lower the foot lever until the notch (C) is right above the pin (D) of the pressure foot
area. Press E and lift the pressure foot so that pin D is exactly C recess, then loose
lever E.
Figure 3. Removing the pressure foot.
Lift the pressure foot lever, press lever E and the pressure foot falls off.
Presser
foot lever
No.18
A
E
B
D
E
C
Presser
foot
21
Threading the upper thread.
For quick and easy installation of the upper thread follow the numbers 1 to 8 by the black
dotted line in the diagram below. The enlargements can be a clarification of the step.
1.
Put the bobbin on the bobbin winder (no.5) and guide the thread through the winding
thread guide (no.7) from the back to the front.
2.
Push thread tension release bar to left, then guide the thread down between the
tension disc making sure that the thread has been inserted into the tension disc.
3.
Continue to draw the thread down and around the thread pulling bar fixed holder
spring from left to right.
4.
Draw the thread up, through the take-up lever draw from left to right.
5.
Continue to draw the thread down through the thread take-up lever from front to
back.
6.
Drawing down the thread and through the lower guide from back to front.
7.
Continue to draw down the thread through the thread protector.
8.
Finally thread the needle from front to back (important !!!!)
Fixed thread holder
22
Publicidad
