Programmming Procedure; Normal Menu - Televes QPSK-PAL Manual De Instrucciones

User manual
5. - PROGRAMMING PROCEDURE
To carry out the configuration of each
QPSK-PAL module, it is necessary to use
the programmer and follow the following
steps:

5.1.- Normal menu

Insert the programmer in the front connector
of the QPSK-PAL programming module
("PRGM"). First, the version of the software
in use, will appear. For example 4.00:
a.- Output channel
Once a couple of seconds have passed, the
first menu appears; the output frequency,
for example 174.25 MHz:
To change the value indicated, it is
necessary to press the button, this will
make the selected digit blink on and off. By
using the and buttons, the value of the
digit is changed. By pressing the
again, the following digit is selected, that
can be changed in the same way. When the
cursor is on top of the decimal digit/s, and
when pressing the
the following permitted digits will appear:
• .0 => .00 MHz
• .2 => .25 MHz
• .5 => .50 MHz
• .7 => .75 MHz
Input values range is from 46 to 862 MHz.
The selection of the output channel is
possible if the channel mode has been
chosen (see extended menus). In this case,
the number of the chosen channel will
appear, for example, channel 5:
In this case, only the
select the desired channel.
b.- Output level
By pressing the
gain access to the output level selection. In
this case, there is no cursor for the selection
of the digit, and instead the
buttons are used to choose the output level
between 00 (minimum) and 99 (maximum).
button
For example, 85:
54
c.- Input Frequency
and buttons, only
The following menu allows the user to enter
the Input frequency. This is done in the
same way as the output frequency menu.
The
that you wish to modify, and you can either
increase or decrease its value using the
and
input frequency values is from 950 - 2150
MHz. For example, 1334 MHz:
d.- Symbol rate
and buttons can
By pressing the
menu appears on the display. This is the
Symbol Rate, for example 27.50 Mbaud:
button, it is possible to
This is done in the same way as the input
channel; the
and
between the different individual digits for the
symbol rate and the
modify the selected digit. The range of
values permitted for the symbol rate is from
3.00 to 45.00 Mbaud.
If the cursor is placed on the digit that
QPSK-PAL
button allows you to select the digit
buttons. The range allowed for the
button, the following
button allows you to choose
and buttons