Parameter Recording; Status Leds - Televes QPSK-PAL Manual De Instrucciones

User manual
There are 7 possible channel tables that can
be selected using the following menu:
Table 1: CCIR, New Zealand and Indonesia.
Italian channels.
Table 2: China, Taiwan
hyperband.
Table 3: M/N, Chile.
Table 4: France.
Table 5: Australia.
Table 6: South Africa, K1 (8 MHz), I (Ireland,
8 MHz).
Table 7: Old USSR and OIRT.
j.- MPEG decoder version
Indicates the software version of the MPEG
decoder. For example; Version 2.10:

5.3.- Parameter recording

To record the data, it is necessary to press
the button for approximately 3 seconds.
When the data is correctly recorded, the
following appears on the programmer's
and CCIR
display:
If the configuration data is modified but is
not recorded, the previous configuration is
recuperated once 30 seconds has passed,
in other words, the changes carried out are
cancelled.
Whenever an input parameter is modified
(input frequency and/or symbol rate) and
once the unit has managed to lock onto the
input signal, an automatic search of all the
available services will be carried out. The
time this takes depends on the number of
services that the transponder has. Whilst the
analysis is taking place, the display will
show the following message:
During the analysis of the input signal, it is
not possible to carry out any other operation
with the programmer.

5.4.- Status LEDS

Finally, the programmer's LEDS indicate the
following operational status:
If the LEDs are switched on, this means that
it is working properly. If one of them is
switched off, this means that something is
not working properly.
NOTE:
The "C" LED will switch off if the selected
program is encoded. If it is an free pro-
gram, it wil switch on.
58
QPSK-PAL
A B C
Correct operation
A B C
Insufficient input signal level
A B C
Unlocking of the QPSK demodulator
A B C
Encoded selected program