Descargar Imprimir esta página

Powerworks XB 20V BLP303 Manual Del Operador página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

10.2
ASSEMBLE AS A BLOWER
1. Align the grooves (5) with the tabs (4) in the blower tube.
2. Install the tube onto the blower housing until the tabs
engage the grooves.
3. Turn the tube in the direction of the arrow until the two
tabs lock into the positions.
10.3
ASSEMBLE AS A VACUUM
WARNING
Make sure that the machine is in the OFF position, and the
impellers stop before you attach or remove tubes.
1. Connect the collection bag to the machine in the same
procedures as blower tube.
2. Connect the blower tube to the air vent in the same
procedures as above.
English
4
5
10.4
INSTALL THE BATTERY PACK
WARNING
If the battery pack or charger is damaged, replace the
battery pack or the charger.
Stop the machine and wait until the motor stops before
you install or remove the battery pack.
Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
10.5
REMOVE THE BATTERY PACK
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
11
OPERATION
WARNING
Make sure the blower tube is in position before operation.
11.1
START THE MACHINE
1. Pull the trigger (1) to start the machine.
2. Push the trigger to increase the speed.
3. Release the trigger to decrease the speed.
7
EN

Publicidad

loading